Cecilware JAVA2-LP User Manual download pdf (Page 2)

INSTALLATION

Water Inlet Connection:

This equipment is to be installed to comply with the applicable Federal, State, or local plumbing codes having jurisdiction. In

addition:

1. A quick disconnect water connection or enough ext

ra coiled tubing (at least 2x the depth of the unit) so that the machine

can be moved for cleaning underneath.

2. An approved back flow prevention device, such as a double check

valve to be installed between the machine and the water

supply.

The JAVA2-LP is equipped with a 1/4"

Flare Water Inlet Fitting, located on the lower left side in the back of the base.

HIGHLY RECOMMENDED:

A WATER SHUT-OFF VALVE and A WATER FILTER, pref

erably a combination Charcoal/Phosphate Filter, to remove odors and

inhibit lime and scale build up in the machine. Note: In areas with extremely hard water, a water softener must be installed

in order to prevent a malfunctioning of the equipment and in order not to void the warranty.

STARTUP PROCEDURE

Caution: Make sure that the Heater Switch, located behind right hopper with door opened,

is in the OFF position.

1. Connect the 1/4" dia copper waterline to the 1/4" flare water inlet fitting of the valve.

2. Plug the power cord i

nto a proper receptacle.

3. Activate the Power Switch (Toggle Up). T

he door display panel and the green dispense buttons will light up and the tank

will start filling. Allow approximately 2 minutes for the tank to fill.

4. Activate the Heater Switch. Allow approximately 15 - 20 minutes for

the water to reach a preset temperature of

200°F. The heat up time will depend on the water inlet temperature, the input voltage and the wattage of the elements

in the machine.

5. Place cup under nozzle and press dispense switch. The machine will dispense wat

er at the rate of 1-1.3 oz. per second.

Repeat it several times for each dispen

se switch to check for consistent output.

6. While the tank is heating up, remove the hoppers, load them with products and reposition them back in the machine.

When the heater light goes OFF, t

he tank has reached its brew temperature and the machine is ready to dispense Coffee.

VOLUME AND DRINK SIZE ADJUSTMENTS:

1 2 3 4 5 6 7 ... 11 12

No comments

Cecilware JAVA2-LP User Manual Page 2