Cecilware JAVA2-LP User Manual download pdf (Page 3)

PROGRAMMING INSTRUCTIONS FOR AUTOMATIC DISPENSE

1. Turn Power Switch ON (toggle switch inside door).

2. PRESS and HOLD [red] STOP Button with one hand.

3. PRESS and HOLD [green] DISPENSE Button with other hand.

4. RELEASE [red] STOP Button ONLY.

5. Continue to HOLD [green] DISPENSE Button for 5 SECONDS, then RELEASE.

6. PRESS and RELEASE [green] DISPENSE Button. Product begins dispensing.

When it reaches the "DESIRED VOLUME",

7. PRESS and RELEASE [green] DISPENSE Button to SET "DESIRED VOLUME".

DISPENSE Button can be "jogged" to top off.

8. PRESS and RELEASE [red] STOP button to LOCK IN "DESIRED VOLUME".

Repeat steps 1 to 8 for each Dispense Button.

PROGRAMMING INSTRUCTIONS FOR MANUAL DISPENSE

1. PRESS AND HOLD STOP [red] BUTTON WITH ONE HAND.

2. PRESS AND HOLD DISPENSE [green] BUTTON WITH OTHER HAND.

3. RELEASE STOP [red] BUTTON.

4. RELEASE DISPENSE [green] BUTTON.

5. PRESS AND RELEASE STOP [red] BUTTON.

The Total Time The Water Is Running Is Accumulated And Saved Into Memory. For Normal Operation,

Press and Release Dispense Button.

The Automatic Dispense Buttons are factory programmed to dispense 8 oz. of Water per cup.

PRODUCT STRENGTH ADJUSTMENTS:

The JAVA units have variable speed control auger motors [CD151 with variable

speed of 10 to 130 RPM].

Drink or Product Strength can be changed by adjusting the Gram Throw Dial on inside door panel.

The Gram Throw is factory preset at approx. 2.4 (2.2 gr. per 8 oz. cup) for the JAVA2-LP machines.

The water flow rate adjustment for the dispense valve should remain fixed bet. 1 - 1.3.

HOT WATER FLOW RATE ADJUSTMENTS:

Note: Remove right side panel to access the Water Dispense Valves, .

TO ADJUST HOT WATER FLOW RATE:

1. Remove right side panel to access the Water Dispense Valves, mounted on tank.

2. Locate adjustment screw on Dispense Valve.

3. Using Allen Key or flat screwdriver rotate, 1/4 turn at a time,

CLOCKWISE to decrease water flow, or COUNTERCLOCKWISE to increase water flow.

4. Check water flow output, after each 1/4 turn.

1 2 3 4 5 6 7 8 ... 11 12

No comments

Cecilware JAVA2-LP User Manual Page 3